The KIPI pellet burner operates automatically and does not require supervision. The rotating combustion tube prevents the accumulation of slag and other combustion residues inside the combustion tube during operation. While the burner is operating, the combustion tube rotates cyclically, causing ash and slag to be discharged from the combustion tube.
The pellet burner is designed for installation in solid fuel boilers, pellet boilers, as well as various gas and oil boilers whose combustion chamber is sufficiently large to allow combustion ash to accumulate at the bottom.
The pellet burner is an environmentally friendly device, as it uses renewable energy sources as fuel. In addition, the burner has low electrical power consumption.
The pellet burner is equipped with a control unit that ensures optimal burner operation based on the operating mode and parameters set by the user. The automation system can be connected to a room temperature sensor and an outdoor temperature sensor. Boiler and domestic hot water sensors are included as standard. The control unit also allows control of the heating system and domestic hot water pumps, as well as the boiler mixing unit.
The burner is equipped with safety automation that blocks fuel supply in the event of overheating or a flame control fault. In the event of a power failure, fuel supply is automatically stopped, preventing damage to the burner and other equipment.
Only pellets with a diameter of ⌀ 6–8 mm and a length of 3.15–40 mm may be used as fuel.
By ordering an additional module, it is possible to monitor and adjust burner operation remotely via the internet (provided the customer has an internet connection).
KIPI Pellet Burner 5–20 kW – Technical Data
Power output: 5–20 kW
Power supply: 230 VAC, 50 Hz (6 A)
Average power consumption: 24 W
Ignition element power: 150 W
Fuel: pellets ⌀ 6–8 mm, length 3.15–40 mm
Modulating power control
Primary and secondary air distribution adjustment not available (preset for wood pellets)
Central heating pump control
Domestic hot water pump control
Room thermostat control
Outdoor temperature-based control (optional)
Controller: EcoMAX 920
Recommended chimney draft: 10–20 Pa
KIPI Pellet Burner 5–20 kW – Dimensions
Combustion chamber diameter (SP): ⌀ 93.6 mm
Installation opening diameter (SZ): ⌀ 114.3 mm
Combustion chamber length (A): 183 mm
Pellet auger conveyor 2 m, with inspection window, two-piece, KIPI.
The auger conveyor is suitable for burners up to 50 kW.
Length: 2 m
Motor power: 50 kW
